Week 10:

For this assignment i'm going to design and make something big using the Shopbot.First of all i thought of designing a stool to use it as a chair and as a table for the laptop as well while i'm setting on the bean-bag.
I searched on the internet for some tutorials to help me then started working.
First step was drawing the design using CorelDraw
After that i laid down the parts in 1:1 scale sheet which was 12mm Thickness, 240 width and 120 height.
Now it's time for Shopbot to start working!!
Before that you must be sure you're using the right endmill, wear your safety equipment because we're going to make some noise!!
TA DA! Say hi for my customizable stool

Assembly:
After about 30 minutes i got to clean the parts and assemble them.